25-302233 Bilstein B8 8100 Series Shock Absorber Rear - Dodge Ram 6.7L Cummins - 4WD 2019-2024 - 0-1" Lift (W/O Air Leveling)

Overview

The Bilstein 25-302233 B8 8100 Series Shock Absorber is an upgraded drop-in replacement shock for your Ram 2500 6.7L Diesel 4WD (Rear) Lifted 2-2.5". With an 18mm piston rod and a 2.65" outer diameter shock body, this reservoir shock offers brute tensile strength while lowering internal gas force ramp-up for a smoother ride. With a wider range of tunability, the 60mm digressive piston gives outstanding comfort without compromising control. The dual piston design of the ZoneControl R technology provides two levels of rebound valving and prevents extreme suspension top-out events, eliminating the need for an external limit strap. Sold Individually.

Features

• Sold Individually
• Made In The USA
• For Models Without Air Leveling Suspension.
• Direct Fit Replacement
• Rebuildable & Revalvable
• 2.65" OD Shock Body & Reservoir
• Billet Reservoir Mount Solution Included
• Vehicle-Specific Shock Tuning Provides An Optimum Ride & Handling Experience
• Billet Rod End With Vulcanized Mounts For An Exact OE Fit & Long Term Durability
• 60mm Remote Reservoir Offers Increased Oil Capacity For Consistent Performance Over Rough Terrain
• 18mm Piston Rod Provides Brute Tensile Strength & Reduces Internal Gas Force Ramp-Up Providing A Smoother Ride
• 60mm Large Bore Digressive Piston Offers A Greater Range Of Tunability & Delivers Exceptional Comfort Without Sacrificing Control

Specifications & Measurements

• Collapsed Length: 16.75"
• Extended Length: 24.77"
• Collapsed Length: 425.5 mm
• Extended Length: 629.2 mm
• Finish : EVO Grey
• Reservoir: Yes
• Body Design: Smooth Body (Non-Coilover)
• Body Diameter (ID): 60mm
• Spring Seat Included: No
• Adjustable Damping: Non-Adjustable

Warranty

• 2 Years Limited

Note

Due to the variety of aftermarket suspension systems, it is recommended to take precise measurements to ensure proper shock fitment. For a pin-to-eye shock, the correct measurement should be taken from the base of the stem, where the mounting hardware rests, to the center of the eyelet.